Bosch SPS40C12GB Instruction Manual page 27

Hide thumbs Also See for SPS40C12GB:
Table of Contents

Advertisement

Fault
Displays flash.
Refill indicator for salt `
and/or rinse-aid X is lit.
Refill indicator for salt `
and/or rinse-aid X is not
lit.
Water is left in the
appliance at the end of the
programme.
Utensils not dry.
Plastic utensils not dry.
Cause
Door not closed properly.
No rinse aid.
No salt.
Sensor does not detect salt
tablets.
Refill indicator switched off.
There is still enough special salt/
rinse aid available.
Filter system or area under the
filters 1R is blocked.
Program has not ended yet.
No or too little rinse aid in the
dispenser.
Programme selected without
drying.
Water collecting in depressions
on the utensils and cutlery.
The combined detergent used
has a poor drying performance
Intensive drying to increase
drying not activated.
Utensils were removed too early
or drying process had not ended
yet.
The eco rinse aid used has a poor
drying performance.
Special properties of plastic.
Fault, what to do?
Remedial action
Close the door. Ensure that no objects
(utensil, fragrance dispenser) are protruding
over the basket and preventing the door
from closing.
Refill rinse aid.
Refill with special salt.
Use different special salt.
Activation/deactivation (see chapter Water
softening system/Special salt or Rinse aid).
Check refill indicator, levels.
Clean filters and area underneath (see
"Waste water pump").
Wait until programme ends or reset (see
"Terminating the programme").
Refill rinse aid.
Select programme with drying (see
"Overview of programmes", "Programme
sequence").
Arrange utensils in a sloping position,
arrange affected utensils as sloping as
possible.
Use different combination detergent with
better drying performance. Use of rinse aid
also increases the drying performance.
Activate intensive drying (see "Operating the
appliance")
Wait until program ends or wait until 30 min
after program ends before removing
utensils.
Use a proprietary rinse aid. Eco products are
much less effective.
Plastic has a lower heat storage capacity
and therefore dries less well.
en
27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents