Rinse Aid; Setting Amount Of Rinse Aid - Bosch SPS40C12GB Instruction Manual

en

Rinse aid

Rinse aid
R i n s e
As soon as the rinse-aid refill
indicator X is lit on the fascia, there
is still a rinse-aid reserve of 1-2 rinsing
processes. Refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only
rinse aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH,
26° Clarke, 3.7 mmol/l) only. If
the water hardness is over 21° dH,
rinse aid must be used.
1. Open the dispenser 1j by pressing
and lifting the plate on the cover.
2. Carefully pour rinse aid up
to the max. mark in the filler opening.
12
a i d
3. Close cover until it clicks shut.
4. To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.

Setting amount of rinse aid

The amount of rinse aid dispensed can
be set in 4 stages. Accordingly 0, 1, 2
or 3 displays are lit (see water hardness
table).
Factory setting: 2.
Do not change the amount of rinse aid
unless streaks (select lower
setting) or water stains (select higher
setting) are left on the utensils.
1. Close the door.
2. Switch on ON/OFF switch (.
The Cleaning display )* flashes.
3. Press and hold down the START
button @.
4. Rotate programme selector 8 until
the rinse aid refill indicator X
flashes.
5. Release button.
The rinse aid refill indicator X
flashes and the displays )"
and h are lit (= Setting 2).
To change the setting:
1. Rotate programme selector 8 until
the required setting has been
selected.
2. Press START button @.
The rinse-aid refill indicator X goes
out. The selected setting is saved.