Fault Table - Bosch SPS40C12GB Instruction Manual

en Fault, what to do?

Fault table

Fault
"Check water supply"
display h lights up.
Display "Check water
supply" h flashes.
Refill indicator for salt `
flashes.
26
Cause
Supply hose kinked.
Tap turned off.
Tap jammed or calcified.
Filter in the water supply blocked. Switch off the appliance and pull out the
Filters 1R are soiled or
blocked.
Waste-water hose kinked or
blocked.
Siphon connection still sealed.
Waste water pump blocked or
cover on the waste water pump is
not locked in position.
A technical fault has probably
occurred.
Heating element calcified or
soiled.
Remedial action
Install supply hose without kinks.
Turn the tap on.
Turn the tap on.
Flow rate must be min. 10 l/min. when
water supply is open.
mains plug. Turn off the tap. Unscrew water
connection.
Clean filter in the supply hose. Screw water
connection on again. Check for leaks.
Reconnect power supply. Switch on the
appliance.
Clean filters.
(see "Cleaning and maintenance").
Install hose without kinks, remove any
residue.
Check connection to siphon and open if
required.
Lock cover correctly.
(See "Waste water pump")
Switch off appliances with the ON/OFF
switch (. After a short time restart the
appliance.
If the problem recurs, turn off the tap, pull
out the mains plug and call customer
service.
Clean appliance with dishwasher cleaning
agent or descaler. Operate the dishwasher
with water softening system and check the
setting (see chapter "Water softening
system/Special salt").