Advertisement
Quick Links
Advertisement
Related Manuals for Sennheiser evolutionwireless G3
Summary of Contents for Sennheiser evolutionwireless G3
- Page 1 Shortguide...
- Page 2 The new G3 series Sennheiser’s evolution wireless G3 system consists of three series: 100, 300 and 500. Even though the series are rather different you will find that the basic operating concept is very much the same for all series.
- Page 3 evolution G3 shortguide Getting started This part will take you through basic use of BodyPack- and handheld microphone sets from the 100 series. Please use 10 minutes of your time to read this quick guide. Since the operating concept for all series basically is very similar, this guide can also be used if you want to set up wireless equipment in the 300 and 500 series.
- Page 4 evolution G3 shortguide • The little locker icon indicates that lock mode is activated, meaning that you cannot change any of the receiver’s parameters. The lock-icon, however, is not activated first time you turn on the receiver, meaning no icon shown at this time.
- Page 5 evolution G3 shortguide The standard display is showing the transmitter’s present status. Frequency is 782.100 MHz, if you turn on the transmitter for the first time. Battery status is illustrated by a small battery icon to the right (3 tiny squares means batteries are full) and “P” means that a facility called “Pilot tone evaluation”...
- Page 6 evolution G3 shortguide The yellow lamp lights up only when the sound level is getting too high and causes distortion. This results in ugly and noisy sound with low speech intelligibility. It is OK for the lamp to blink occasionally, but not all the time. If it goes on blinking press SET twice and arrow DOWN once or twice until the lamp stops blinking.
- Page 7 evolution G3 shortguide Next to the display - just above the transmitter antenna - is a small wheel. This wheel is used to change and adjust levels and the parameters of the transmitter. Please note that the microphone is suited with a protection ring (available in different colours) to avoid changes caused by non-intentionally pressing the control buttons.
- Page 8 evolution G3 shortguide Press the wheel into the body (SET) to store the change. Display is showing “Stored”. Briefly press the red button to get back to the standard display. When you want to turn off the transmitter, hold down the red button a few seconds until the display shows “OFF” and the red ON light goes off.
- Page 9 However, evolution wireless G3 has an outstanding ability to handle this problem and make operating wireless systems easy for you. Furthermore, the G3 systems are pre-programmed by Sennheiser making 20 different wireless bank setups (= groups of frequencies) available to you, all ready to use.
- Page 10 evolution G3 shortguide Most likely it will tell you: Bank 1 and ”Free:12”, meaning that all 12 frequencies in bank 1 are free for you to use. In this example, however, we will use the Nordic legal frequency area of 800 – 820 MHz. Continue by doing: Find Bank 3 using the UP/DOWN arrows.
- Page 11 evolution G3 shortguide Extra equipment and accessories A wide range of accessories fulfills the highest standards of technical compatibility. This might not be absolutely necessary for a system to work, however, it will in most cases enhance the quality of sound and the reliability of a system. A high-end microphone will enhance sound quality remarkably.
- Page 12 Sennheiser Nordic A/S Denmark • Skovlytoften 33 • DK-2840 Holte Phone: +45 70 26 66 33 • Fax: +45 70 26 67 11 e-mail: sennheiser@sennheisernordic.com • www.sennheisernordic.com...
Need help?
Do you have a question about the evolutionwireless G3 and is the answer not in the manual?
Questions and answers