LG MFL06206505 Installation Instructions Manual page 15

STEP 6: Attach The Oven To The Wall
To avoid risk of personal injury or property damage, you will need two people to
install this microwave oven.
NOTE:
● Do not apply force directly to the outside bottom surface of the product.
The slide-out vent latch may be damaged if force is applied directly to the center bottom of the product.
● Set the product down on a flat surface only.
During unpacking, gently set the product onto a flat surface such as a
kitchen table or counter.
● Do not lift or support the product by the bottom center surface.
The product is best handled by the bottom sides near the legs.
● Do not remove the packing tape on the slide-out vent during installation.
Once the product is fully installed, remove the tape and check that the vent
easily slides open and closed with a push.
1. Carefully lift microwave oven and hang it on support tabs
(See Figure 30) at the bottom of the mounting
plate.Reaching through upper cabinet, thread
power supply cord through the power supply cord
hole in the bottom of the upper cabinet.
See Figure 32.
2. Rotate the microwave oven upward so the top of the
oven is against the bottom of the upper cabinet or cabinet
frame.
3. Then insert a bolt down through each hole in the
upper cabinet bottom.See Figure 33.
Tighten the bolts until the gap between the upper cabinet
and microwave oven is closed.
4. Roof venting installation: See Figure 34.
Install ductwork through the vent opening in the
upper cabinet. Use caulking gun to seal the exterior roof
opening around the exhaust cap. See Figure 7 on page 7.
5. Use the power supply cord clamp to bundle the power
supply cord. Install the power supply cord clamp, using a
screw as shown in Figure 35, to the inside of the cabinet.
6. Grasp the filter screen with one hand holding the ring and the
other hand holding the opposite end. Insert the end of the
filter screen without ring into the opening and slide
towards the side of the microwave oven. Insert ring end of
filter screen into the opening and slide entire screen
towards the center of the microwave until screen is
securely in position. Repeat for other filter screen. See
Figure 36.
7. Plug in the power supply cord.
8. Read your Owner's Manual, then check the operation of
your microwave oven.
w
W A R N I N G
– 15 –
Power Cord
Power Cord
Hole
Figure 32
Figure 33
3
2
1
1
2
Figure 36
Damper
Figure 34
Power
supply
Cord
Clamp
Figure 35