LG MFL06206505 Installation Instructions Manual page 10

STEP 3: Prepare The Venting Blower
WALL-VENTING INSTALLATION:
1. Remove one or two blower unit mounting screw(s) and one
or several blower plate mounting screw(s). Remove the
blower plate from the cabinet. See Figure 13.
2. Carefully lift the blower unit out of the microwave oven.
See Figure 14.
3. Use side cutters or tin snips to cut and remove knockouts
B from Back plate. Discard knockouts. Be careful not to
distort the plate. See Figure 15.
4. Reassemble the blower wire. See Figure 16.
5. Rotate and reinstall the blower unit so that the exhaust
ports face the rear of the cabinet and are aligned with the
rear cut-outs. See Figures 17 & 18.
6. Reattach the blower plate to microwave oven so the exhaust
ports and blower plate opening are aligned. Attach with one
blower unit mounting screw and then one or several blower
plate mounting screw(s). See Figure 19.
7. Insert the tabs on each side of the damper into the holes
at the inside rear of the adaptor.
Attach the exhaust adaptor to the back plate wall side.
Push in securely until it is past the top locking tabs
and in the lower locking tabs. Take care to assure
the damper hinge is installed so that it is at the top
and that the damper swings freely. See Figure 20.
Figure 16
Blower Unit
Blower Unit
Exhaust Ports
Figure 19
Blower Plate
Mounting Screw
Blower Plate
Back Plate
Blower Unit
Mounting Screw
Blower Unit
Blower
Unit
Exhaust Ports
Figure 17
Exhaust Adaptor
Slide exhaust
adaptor into
guides on
rear panel.
– 10 –
Blower Plate
Mounting Screw
Blower Unit
Mounting Screw
Parts B
Figure 13
or
Figure 14
Parts B
Figure 15
Exhaust
Ports
Figure 18
Locking
Tabs
Figure 20
Blower Plate
Back Plate
Knockouts Parts B
Damper
(hinge side up)
Guides