Inter-m IMN-511 Operation Manual page 19

Wiring the DC Iris Lens
-
RED(power) to Pin #1
RED(DAMP -) to Pin #1
N.C(not connected) to Pin #2
BLACK(DAMP +) to Pin #2
* What is a DC iris lens? A DC iris lens has only an iris
controlling coil which opens and closes an iris without an
iris controlling circuit inside a lens. So a lens controlling
circuit is configured in a camera to receive the control
signals (DC) sent by the camera lens so as to provide the
constant image output.
4) Connect the connection plug (connected to a lens cable) to
the auto lens connector on the back of the product.
IMN-511/512
5) If you use a DC iris lens, select DC from the lens selection
switch; if a video iris lens, select VIDEO.
IMN-511/512
* Recommend Auto Iris Lens in the condition of bad lighting
condition.(The place where lighting is continuously changing)
IMN-511/512(HIGH RESOLUTION IP CAMERA)
WHITE(video signal) to Pin #3
WHITE(DRIVE +) to Pin #3
GREEN(DRIVE -) to Pin #4 BLACK(ground) to Pin #4
17