Installation Check - LG DLEX0001TM Service Manual

10-2 Installation check

This feature allows you to quickly verify that the exhaust system is adequate for the normal function of the
dryer. The check takes only two minutes. The results of the check are displayed in the FlowSense display
window as shown below
(Fig. 1). The dryer must be at room temperature for this test to be reliable. To perform this test, start the
machine following check steps.
1 Step : Turn on the dryer by pushing the Power button
2 Step : Turn the Knob right or left.
3 Step : Press the option button one time, it'll be displayed Off.
4 Step : Press CUSTOM PGM one time, it'll be change Off to On
5 Step : Press the Start button When display the "FLOW CHECK" in screen,
"FLOW CHECK" will be displayed from pushing the EXIT button or
waiting 3 seconds.
The dryer will start and run for 2 minutes while it checks temperatures. At the end of this short cycle, it will
display the results as follows.
Fig.1
1
After Installation Check,
If duct shows....
2 5
OR
4
If NO Bars are shown in the
display, ductwork is free from
any blocking or restrictions.
If 4 Bars are shown in the display,
ductwork is blocked and need to
be cleaned immediately.
23
3