Special Requirements For Manufactured Or Mobile Homes; Final Installation Check - LG DLGX3071 Series Owner's Manual

28
INSTALLATION INSTRUCTIONS
Special requirements for
manufactured or mobile homes
Any installation in a manufactured or mobile home must comply
with the Manufactured Home Construction and Safety Standards
local codes and ordinances. If you are uncertain whether your
proposed installation will comply with these standards, please
contact a service and installation professional for assistance.
connection. More detailed information concerning the electrical
connection is provided in the section Connecting Electric Dryers.
vented to the outside.
home.
right, or bottom panel.
or bottom panel. Gas dryers may not be vented to the outside
using the right side panel because of the burner housing.
manufactured or mobile home structure, and the exhaust duct
must be made of a material that will resist fire and combustion.
It is recommended that you use a rigid or flexible metal duct.
chimney, or other exhaust duct.
ensure proper operation. The opening for outside fresh air must
).
venting the dryer to the outdoors, the dryer can be installed with
the dryer. You should obtain the venting materials necessary for
proper installation.

Final installation check

Once you have completed the installation of the dryer and it is
in its final location, confirm proper operation with the following
tests and
page.
Testing dryer heating
Close the dryer door, press the ON/OFF button to turn the dryer
on, and start the dryer on a heat setting. When the dryer starts,
the igniter should ignite the main burner.
NOTE
If all air is not purged from the gas line, the gas igniter may turn
off before the main burner ignites. If this happens, the igniter
will reattempt gas ignition after approximately two minutes.
Close the dryer door, press the ON/OFF button to turn the dryer
on, and start the dryer on a heat setting. The exhaust air should
be warm after the dryer has been operating for 3 minutes.
Checking airflow
Effective dryer operation requires proper airflow.
The adequacy of the airflow can be measured by evaluating
the static pressure. Static pressure in the exhaust duct can
be measured with a manometer, placed on the exhaust duct
with no load.
Checking levelness
Once the dryer is in its final location, recheck the dryer to be sure
it is level. Make sure it is level front to back and side to side, and
that all 4 leveling feet are firmly on the floor.
on the following