Kenwood TK-8302 Service Manual page 31

Item Condition
3. Low Power 1) CH: TX low
(Auto) CH: TX low'
(Narrow) CH: TX center
CH: TX high'
• TK-8302 CH: TX high
2) Transmit
• TK-8302H
4. DQT 1) CH: TX low
Balance CH: TX low'
(Wide) CH: TX center
CH: TX high'
CH: TX high
2) Deviation meter fi lter
LPF: 3kHz
HPF: OFF
3) Transmit
5. Maximum 1) CH: TX low
Deviation CH: TX low'
(Wide) CH: TX center
CH: TX high'
CH: TX high
2) Deviation meter fi lter
LPF: 15kHz
HPF: OFF
3) Transmit
6. MIC 1) CH: TX center
sensitivity AG: 1kHz/5mV
2) Deviation meter fi lter
LPF: 15kHz
3) Transmit
7. DQT 1) CH: TX center
Deviation 2) Deviation meter fi lter
(Wide) LPF: 3kHz
HPF: OFF
3) Transmit
8. QT 1) CH: TX center
Deviation 2) Deviation meter fi lter
(Wide) LPF: 3kHz
HPF: OFF
3) Transmit
9. DTMF 1) CH: TX center
Deviation 2) Deviation meter fi lter
(Wide) LPF: 15kHz
HPF: OFF
3) Transmit
10. MSK 1) CH: TX center
Deviation 2) Deviation meter fi lter
(Wide) LPF: 15kHz
HPF: OFF
3) Transmit
ADJUSTMENT
Measurement
Test-
Unit Terminal Unit
equipment
Power ANT
meter
Ammeter
Deviation
meter
Deviation ANT
meter
Oscillo-
scope
AG
AF VTVM
ANT
MIC
ANT
TK-8302/8302H
Adjustment
Parts Method
FPU 5W ±0.5W
4.0A or less
25W ±1.0W
8.0A or less
The Deviation of ±0.4dB
20Hz frequency
is fi xed. (FL=30,
FLC=35, FC=40,
FCH=45, FH=50)
Change the 1kHz
adjustment value to
become the same
deviation of 20Hz
within the specifi ed
range.
4.4kHz ±0.1kHz
(According to the
large +, –) Note:
FPU auto input 1kHz/50mV
Check 2.2kHz~3.6kHz
FPU 0.75kHz ±0.05kHz
0.75kHz ±0.05kHz
3.0kHz ±0.1kHz
3.0kHz ±0.1kHz
Specifi cations / Remarks
31