Related Manuals for King Technology SPARCO CYCLER
Summary of Contents for King Technology SPARCO CYCLER
- Page 1 Sparco Cycler Pool Care for Above Ground or In Ground Pools INSTRUCTION MANUAL R MO...
-
Page 2: Table Of Contents
Replacing Control Dial O-Rings Replacing Cap O-Ring Replacing Knob Winterizing Parts List In Ground In-Line Installation Above Ground Filter Installation Above Ground Base Installation For Proper Performance Warranty Back Page For information on King Technology’s entire product line, visit our website at www.kingtechnology.com... -
Page 3: Introduction
Welcome to easier pool care that ensures crystal clear, sparkling water in your pool. This manual will explain how to install and operate the Sparco Cycler for a more enjoyable experience with less work and worry and more time relaxing and having fun. -
Page 4: Start-Up And Operation
Follow manufacturer's directions carefully. • Insert chamber into Sparco Cycler. • Replace cap and set the control dial on the Sparco Cycler. (Follow directions for replacing a (Follow directions for setting dial below.) chamber on Page 6.) Setting Control Dial 1. -
Page 5: Replacing Sparco Chamber
CAUTION Read Carefully – USE ONLY the factory recommended replacement chamber. chamber (See label.) DO NOT USE any other chamber or bulk chemical tablets in the Sparco Cycler. Use of any other product could result in over chlorination, bleached liners, unsafe pool conditions, fire or explosion. -
Page 6: Replacing Control Dial O-Rings
OTHER COPY? xxxxx o-ring without stretching it. SILICONE LUBRICANT silicone lubricant that came SLICONE LU BRICANT Apply silicone lubricant, that with your Sparco Cycler. DO COPY COPY came with your Sparco Cycler, COPY NOT USE petroleum based on o-ring. COPY lubricants. -
Page 7: Winterizing
Make sure chamber is away from open flame or anything metal. Unscrew knob in the back • of Sparco Cycler. Allow all water to drain. Replace the cap and knob • loosely. Parts List CYCLER DIAGRAM/PARTS LIST REF. -
Page 8: In Ground In-Line Installation
Following pipe thread sealant Check Valve turning 1 to 2 directions, brush sealant on DO NOT USE TEFLON revolutions to Sparco Cycler threads in TAPE as the threads with wrench. both ports. on these units 1 1/4" Phillips Pan DO NOT... -
Page 9: Above Ground Filter Installation
Screw a bushing are not suitable into each port of for this use and leaking Sparco Cycler and hand Brush sealant on threads of one or bushing failure could tighten. result. Brush sealant on threads of... -
Page 10: Above Ground Base Installation
SYSTEM start-up to ensure proper back pressure. TO POOL MATERIALS NEEDED: The Sparco Cycler should always be installed between the filter and pool (or between heater and pool if applicable). Pipe Thread P IP E Sealant C Y C LE R... -
Page 11: For Proper Performance
WATER TREATMENT SYSTEM equipment. PUMP NOTE: Over chlorination or damage to the Sparco Cycler or other equipment could result if these special installations are not ➜ ➜ POOL WATER LEVEL used in these situations. C. Pool and Spillover Spa Combination... -
Page 12: Warranty
1. To obtain warranty service, you must deliver the unit to King Technology or its nearest authorized dealer. Shipping expenses 4. This warranty is the exclusive warranty for the Sparco Cycler. are the purchaser's responsibility. The name of the nearest This warranty is not transferable.
Need help?
Do you have a question about the SPARCO CYCLER and is the answer not in the manual?
Questions and answers