Table of Contents
Advertisement
Initial Setup
To access the Main menu and begin setup, follow these steps:
1
Press the Menu button.
3
The Main menu is the first menu you see.
em Vi
ew
Sy st
at or
Op er
ta ll
kI ns
Qu ic
Ma in
8
| Initial Setup
2
Enter the installer password by using the
number buttons.
For 4-camera models, enter 3444.
For 10- and 16-camera models, enter 3477.
Bo x
wo rd
Pa ss
wo rd
Pa ss
ne w
r a
En te
-- --
Factory Defaults
Before you program your DVMRe, return all
settings to the factory defaults. To do this:
1
Jog in the Main menu to Factory Settings
and press Enter.
2
Enter the Factory Default password: for
4-camera models, 4111; for 10- and
16-camera models, 8111.
The DVMRe reboots, reverting all settings
except time, date and IP address to factory
defaults. The DVMRe beeps when resetting is
complete.
Settings
Record Quality:
High
Event Settings:
Event and TL
Pre Event Duration:
02
Record Mode:
Continuous
Motion Detection:
Enabled
setup parameters:
Active
sensitivity:
5
relay output:
None
link to event:
Yes
Camera Titles:
Camera 01, Camera 02, etc.
Camera AGC:
50%
Cameras:
Enabled
RS232 Port 1:
57600 Baud
RS232 Port 2:
19200 Baud
RS485:
Network address 001
Ethernet:
Enabled
POTS:
Disabled
Advertisement
Table of Contents
Need help?
Do you have a question about the DVMRe Triplex and is the answer not in the manual?