Approved Vent Components; Misc. Codes/Standards; Inputs And Efficiencies - Superior DRT63STTEN Installation And Operation Instructions Manual

INNOVATIVE HEARTH PRODUCTS • SEE-THROUGH DIRECT-VENT GAS FIREPLACES (DRT63STTEN/P) • INSTALLATION INSTRUCTIONS

Approved Vent Components

These fireplaces are designed, tested, and listed
for operation and installation with the following
vent components (8" inner and 11" outer) only:
• Secure Vent ™ SV8 direct-vent system com-
ponents manufactured by Security Chimneys
International.
These approved vent system components are
labeled for identification. Do NOT use any other
manufacturer's vent components with these
appliances.
Children and adults should be alerted to the
hazards of high surface temperature and
should stay away to avoid burns or clothing
ignition.
Les enfants et les adultes devraient être
infor-més des dangers que posent les
températures de surface élevées et se
tenir à distance afin d'éviter des brûlures
ou que leurs vêtements ne s'enflamment.
DO NOT ATTEMPT TO ALTER OR MODIFY
THE CONSTRUCTION OF THE APPLIANCE OR
ITS COMPONENTS. ANY MODIFICATION OR
ALTERATION MAY VOID THE WARRANTY,
CERTIFICATION AND LISTINGS OF THIS UNIT.
WARNING
Improper installation, adjustment,
alteration, service or maintenance
can cause injury or property
damage. Refer to this manual. For
assistance or additional informa-
tion consult a qualified installer,
service agency or the gas supplier.
WARNING
Failure to comply with these
installation instructions will
result in an improperly installed
and operating appliance, voiding
its warranty. Any change to this
appliance and/or its operating
controls is dangerous.
WARNING
Clothing or other flammable
material should not be placed on
or near the appliance.
AVERTISSEMENT
On ne devrait pas placer de vête-
ments ni d'autres matières inflam-
mables sur l'appareil ni à proximité.
WARNING
Any safety screen or guard
removed for servicing the appli-
ance must be replaced prior to
operating the appliance.
AVERTISSEMENT
Tout écran ou protecteur retiré pour
permettre l'entretien de l'appareil
doit être remis en place avant de
mettre l'appareil en marche.
WARNING
Improper installation or use of
this appliance can cause serious
injury or death from fire, burns,
explosion or carbon monoxide
poisoning.
Note: Installation and repair should be done
by a qualified service person. The appliance
should be inspected before use and at least
annually by a professional service person.
More frequent cleaning may be required due
to excessive lint from carpeting, bedding
material, etcetera. It is imperative that control
compartments, burners and circulating air
passageways of the appliance be kept clean.
Remarque : L'installation et la répara-
tion devrait être confiées à un technicien
qualifié. L'appareil devrait faire l'objet
d'une inspection par un technicien profes-
sionnel avant d'être utilisé et au moins
une fois l'an par la suite. Des nettoyages
plus fréquents peuvent être nécessaires si
les tapis, la literie, et cetera produisent
une quantité importante de pous-sière.
Il est essentiel que les compartiments
abritant les commandes, les brûleurs
et les conduits de circulation d'air de
l'appareil soient tenus propres.
Do not use these appliances if any part
has been under water. Immediately call a
qualified, professional service technician to
inspect the appliance and to replace any parts
of the control system and any gas control
which have been under water.
Ne pas utiliser cet appareil s'il a été
plongé, même partiellement, dans
l'eau. Appeler un technicien qualifié pour
inspecter l'appareil et remplacer toute
partie du système de commande et toute
commande qui a été plongée dans l'eau.
Only trim kit(s) supplied by the manufacturer
shall be used in the installation of this ap-
pliance.
Seules les trousses de garniture fournies
par le fabricant doivent être utilisées pour
l'installation de cet appareil.
These appliances comply with National Safety
Standards and are tested and listed by PFS
(Report No. F14-107) to ANSI Z21.88 (in
Canada, CSA-2.33), and CAN/CGA-2.17-M91
(CSA P4.1) in both USA and Canada, as vented
gas fireplace.
These appliances are listed by PFS for installa-
tion in bedrooms, aftermarket mobile homes,
and manufactured homes.

Misc. Codes/Standards

Installation must conform to local codes or, in
the absence of local codes, with the National
Fuel Gas Code, ANSI Z223.1/NFPA 54 - latest
edition (in Canada, the current CAN/CSA-B149.1
installation code).
The appliance, when installed, must be electri-
cally grounded and wired in accordance with
local codes or, in the absence of local codes,
with the National Electrical Code, ANSI/NFPA
70 - latest edition, or the Canadian Electrical
Code, CSA C22.1 - latest edition.
Provide adequate clearances around air open-
ings and adequate accessibility clearance for
service and proper operation. Never obstruct
the front or back openings of the appliance.
These appliances are designed to operate on
natural or propane gas only. The use of other
fuels or combination of fuels will degrade the per-
formance of this system and may be dangerous.
The system is switchable between standing
and intermittent pilot modes. External electri-
cal power is required to operate these units.
If the system operates on line voltage, four "AA"
batteries (in receiver) can be used as a backup
in case of a power outage.
These models come standard with a remotely
modulated gas valve. The included transmitter
remotely controls flame appearance and heat
output (manual gas valve adjustment is not
possible).

Inputs and Efficiencies

Appliance BTU inputs are listed in Table 1A.
Appliance efficiencies are listed in Table 1B.
INPUTS
Gas Type
Natural Gas 40,000 to 60,000
Liquid Propane 43,500 to 56,000
Table 1A
EFFICIENCIES
Gas Type
AFUE
Natural Gas 68%
Liquid Propane 70%
Table 1B
Gas Fireplace Energy Ef ciency Rating
Based on CSA P .4.1-02
Inputs (BTU/hr)
EnerGuide
67%
67%
5