Control Codes; Cable Connection; Lan Connector - NEC X554UNS Installation Manual

X554UNS Installation Guide
55" LED LCD Display

Control Codes

NOTE: Contact your NEC rep for codes not listed.
NOTE: Use a cross/reverse/null modem cable.

Cable Connection

Communication Protocol:
Interface: RS-232C
Communication: Asynchronous
Baud Rate: 9600 bps
Data Length: 8 bits
Parity: None
Stop Bit: 1 bit
Communication Code: Hex
PC Control Connector (D-Sub 9P)
NOTE:
If so desired, jumper "Request to send" and "Clear to Send" together on both ends of the cable to simplify cable connection. These
connections are not required. The only connections required are pins 2 (TxD), 3 (RxD) and 5 (GND)
www.necdisplay.com
NEC Display Solutions of America, Inc.
Interface:
Communication Layer:
IP Address:
Port Number:

LAN Connector

Transmit Data+
Transmit Data-
Receive Data+
Not Used
Not Used
Receive Data-
Not Used
Not Used
X554UNS
TCP/IP (Ethernet)
Transport Layer (TCP)
192.168.0.10 (Default)
7142 (Fixed)
Page 6 of 7
Rev 1.0