eMotions Embroidery Machine User Manual page 21

You can use the template to mark the placement of the design on fabric
or a garment.
1. Place the template over the section of the garment where you
want the design to be. With an erasable marker, chalk, air dry
marker, or water soluble marker, mark the four corner holes and the
center. You may also want to mark the vertical and horizontal lines
at the edge of the template.
2. Remove the hoop and connect the lines with your erasable marker.
3. Place the outer hoop under the garment and the stabilizer
and place the inner hoop in the area you have marked for the
placement of the design.
4. Place the template in the inner hoop. The small ledges of the inner
hoop should hold the template in place. The lines on the template
should line up with the arrows on the inner hoop.
5. Adjust the inner hoop on the garment to get it placed according to
your markings. (This is why the transparency film is a good choice.)
When using a paper template, cut along the lines and fold back to
see the markings you have made on the fabric.
6. Once the inner hoop is lined up, adjust the outer hoop to fit. Press
the inner hoop into the outer hoop and check the template again
for proper placement.
Proceed with the hooping instructions on page 18.
eMotions TM 2005 Blosil Enterprises, LLC. Produced under License by OESD, Inc. All manual contents (C) 2005 OESD, Inc.
eMotions Manual 7x9.indd 21
21
7/22/2005 11:11:11 AM