eMotions Embroidery Machine User Manual page 20

The template is ruled in 1 inch squares with the sewing field of the
machine subdivided by ¼" squares. Cut out the template along
the outside edge of the diamond shape. You may want to use a
hole punch to punch out the circles. To get to the center circle, just
barely fold the template so you can punch it. Or you can use a craft
knife and make cross cuts at each circle. These will indicate the
outside edge of the sewing field and the center where the design
will start. You may also want to make a small notch in the top,
bottom and both sides to denote the horizontal and vertical center
lines. These horizontal and vertical center lines correspond with
the arrows of the hoop.
NOTE: The sewing field of your eMotions machine is 100mm x 100mm or 3.93 inches. The
template is marked in inches, therefore the design will always fit within this area.
Mark the horizontal and vertical lines for the center of the design on the
garment to be embroidered. Use the template to make sure the
centers are lined up with the center of the sewing field.
20
eMotions TM 2005 Blosil Enterprises, LLC. Produced under License by OESD, Inc. All manual contents © 2005 OESD, Inc.
eMotions Manual 7x9.indd 20 7/22/2005 11:11:11 AM