Panasonic HC-V770 Operating Instructions Manual page 251

3
Press the recording start/stop button.
(When [Party Scene]/[Moving Object] is selected)
≥ Before recording starts, the Remote Pan Tilt Cradle rotates and returns to its home position. It
takes time until recording starts.
≥ The Remote Pan Tilt Cradle operates within the range set in advance.
(When [Manual]/[Preset Positions] is selected)
≥ Performing the operation of Step 2 during recording may cause the recording screen to shake or
the Remote Pan Tilt Cradle to move from its original location.
To switch the Remote Pan Tilt Cradle Mode
Touch .
≥ The selection screen of the Remote Pan Tilt Cradle Mode is displayed. Touch the desired mode.
To exit the Remote Pan Tilt Cradle
Touch [EXIT].
≥ The Remote Pan Tilt Cradle rotates and returns to its home position.
≥ After the operation, the Remote Pan Tilt Cradle turns off. Before removing this unit, disconnect
the USB cable.
Setting up [Preset Positions]
∫ Registering positions to the position buttons
1 Touch .
2 Touch the position button to which you want to register a position.
≥ You can register positions to [POS1]/[POS2]/[POS3]/[POS4]/[POS5]
≥ The position buttons without a registered position are indicated as [Not set].
3 Determine a position with
≥ You can also operate the zoom with the zoom lever.
4 Touch [ENTER].
≥ To register positions to other position buttons, repeat Steps 2–4.
≥ To adjust a position that has already been registered to a position button, touch the position
button to which the position you want to adjust is registered, and follow Steps 3–4.
∫ Moving the Remote Pan Tilt Cradle to a registered position
1 Touch .
P O S
≥ Check that is highlighted in yellow.
P O S
≥ The position buttons ([POS1]/[POS2]/[POS3]/[POS4]/[POS5]/[HOME]) will be displayed.
These buttons will disappear when no touch operation is performed for approximately 5 seconds.
To display them again, touch the screen.
2 Touch the desired position button.
≥ The Remote Pan Tilt Cradle will move to the registered position of the selected position button.
≥ You cannot select position buttons without a registered position.
≥ If you touch [CANCEL], the Remote Pan Tilt Cradle will stop in a midway position.
≥ To return to the home position, touch [HOME].
∫ Using Cycle Mode
In this mode, the Remote Pan Tilt Cradle cycles through positions registered to the position buttons
in the desired sequence.
The default sequence is as follows: [HOME] # [POS1] # [POS2] # [POS3] # [POS4] # [POS5]
/ / /
- 251 -