Daewoo TACUMA Body Repair Manual page 4

SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
NOTICE: The following precautions should be observed
when performing sheet metal work, paint work and re-
pair work around the locations of the SRS parts.
1. SDM(Sensing and Diagnosis Module) are located
under the console ass'y. Avoid strong impact with
ass'y hammer or other tools when repairing the front
side frame and the lower part of the dashboard. Do
not apply heat to these areas with a gas burner, etc.
2. SRS harness is located under the lower part of the
dashboard below the dashboard panel. (SRS harness
is covered with a yellow corrugated tube.) Care
should be taken not to damage the harness when
repairing this area.
DRIVE SIDE
AIRBAG MODULE
PASSENGER SIDE
A I R B A G M O D U L E
A I R B A G M O D U L E
( S D M )
3. Do not apply heat of more than 80°C(176°F) when
drying painted surfaces anywhere around the loca-
tions of SRS parts.
4. If strong impact or high temperature needs to be
applied to the areas around the locations of SRS
parts, remove the part before performing repair work.
5. If any of the SRS related parts is damaged or de-
formed, be sure to replace it.
NOTE: Refer to the Service Manual(Supplemental Re-
straint System) for removal and replacement of SRS
related parts.
STEERING WHEEL
SERVICE NOTICE
CONTACT COIL