Toshiba Satellite P500 Maintenance Manual page 208

Replacement Procedures
Installing the display assembly
The following describes the procedure for installing the display assembly.
1. Inserting the pole of hinge to the hole of hinge assembly, set the display assembly
on the base assembly.
2. Secure the hinges with the following screws secure the display mask with the
following screws and stick the mask seal on them.
• M2.5×6.5 FLAT BIND screw
NOTE: Be sure to apply the locktight to the screws instructed in the figure above.
3. Connect the LCD harness to the connector on the system board.
4. Arrange the wireless antenna cables along the guide (front) and secure them with
guide.
5. Pass the cables to the back of computer through the slot.
6. Arrange the wireless LAN antenna along the guide and contact with the connector.
7. Install the LAN board and cover ASSY of the system.
NOTE: If Fingerprint or Dust left on LCD screen during disassembly and assembly
LCD units, please follow Appendix A to clean it.
Satellite P500 and Satellite Pro500 Maintenance Manual (960-Q08)
x6 (Locktight)
4-38