Troubleshooting - Beat    receiver Instruction Manual

Bluetooth support usb/ sd interface car cd/ mp3 / wma player / receiver
Table of Contents

Advertisement

21. TROUBLE SHOOTING
Before going through the check list, check wiring connection. If any of the problems persist
after check list has been made, consult your nearest service dealer.
Symptom
The car ignition is not on.
No power
The fuse is blown.
Presence of CD disc inside
Disc cannot be
the player.
loaded or ejected
Inserting the disc in reverse
direction.
Compact disc is extremely
dirty or defective disc.
Temperature inside the car is
too high.
Condensation.
Volume is in minimum.
No sound
Wiring is not properly
connected.
The built-in microcomputer is
The operation keys
do not work
not operating properly due to
noise.
The installation angle is
Sound skips.
more than 30 degrees.
The disc is extremely dirty or a
defective disc.
The antenna cable is not
The radio does not
work.
connected.
The radio station
automatic selection
The signals are too weak.
does not work.
Mechanism Error
ERROR 1
Write Error
The Media Device not able to
copy by the unit.
Read Error
The Media Device not able to
play file by the unit
The media device memory is
Memory Full
full not allow to copy
No file Format supports for
No File
Playback on the disc or
Media Device
Disc Error
Maybe disc dirty / disc scratched
/disc upside down.
Cause
If the power supply is properly connected
to the car accessory terminal, switch the
ignition key to "ACC"
Replace the fuse.
Remove the disc in the player, then
put a new one.
Insert the compact disc with the
label facing upward.
Clean the disc or try to play a new one.
Cool off or until the ambient temperature
returns to normal.
Leave the player to off for an hour or so,
then try again.
Adjust volume to a desired level.
Check wiring connection.
Press the RESET button.
Front panel is not properly fixed into
its place
Adjust the installation angle to less
than 30 degrees.
Clean the compact disc or try to play a
new one.
Insert the antenna cable firmly.
Select a station manually.
Press the reset button to correct the problem.
If the error code does not disappear, consult
your nearest service dealer.
Replace the Media Device or
Replace the Media Device or
Replace the Media device or erase
some un-usage files.
Replace the disc or Media Device..
Replace the disc.
E - 35
Solution

Advertisement

Table of Contents
loading

Table of Contents