Reflector Assembly - Patriot Antenna Rx Installation & Assembly Instructions Manual

Back Frame to Mount assembly
1 . With the help of an assistant, lift the Back Frame assembly and place it onto the
Az-El assy as shown. A t tach using 1" x 6" bolt, flat washer, lockwasher and nut.
2 . Assemble the Elevation Rod as shown using 3/4" nuts, washers(large USS) on
each side of the elevation pivot block, and 1/2" x 1 1/2" bolts, nuts, and washers.
1/2" x 1 1/2" bolts, nuts,
and washers.(2 )

Reflector assembly

1. With the help of an assistant, lift Reflector assembly and place it onto the Back
Frame as shown. Use 3/8" x 1" bolts/washers to fasten. Tighten hardware after all
bolts are in place.
3/8" x 1" bolts/washers (8)
Elevation
Pivot
Block
Large USS 3/4"
Washers (2)
Back Frame
Elevation
Rod
Az-El
assy
assy
1" x 6" bolt, flat washer,
lockwasher and nut.
7