Table of Contents
Advertisement
Setting the Options for Safety Cameras
There are a number of options available when using the speed camera software and these are located under
„Setup‟, „Safety Cameras‟ in the Full Navigation mode.
The options available are:
Enabled / Disabled
This will turn the safety camera software on or off. Please note that if this is set to „Disabled‟ you will not
receive any visual or audible alerts for any safety cameras on your route. Tap the button to change.
Warn At 5 Secs
This will allow you to change the time that you receive the first warning before you reach a safety camera.
The options are „No Warning‟, „Warn at 5 Seconds‟, „Warn at 10 Seconds‟, „Warn at 15 Seconds‟ and
„Warn at 20 Seconds‟.
Smart Warnings
When set to „ON‟ this will warn you about safety cameras on your side of the road only. When set to „OFF‟
the safety camera software will warn you about cameras on both sides of the road.
Show on Map
When this is enabled, the safety camera icon
on your map while you drive. To disable please tap the button to select „Don‟t Show on Map‟
Warning Sounds
This will turn the audible alerts on or off. Tapping the button will change it accordingly.
depicting the location of a safety camera will be shown
57
Advertisement
Table of Contents
