Advertisement
RigMaster Service and Repair Manual
Document # S240909
WARNING
After changing the belt, but before starting the engine, see that the air conditioning
compressor and 120 Volt generator bolts are properly fastened.
Pulley Alignment
When replacing the serpentine belt, 120V generator or drive pulley on a serpentine drive system
you must check the alignment of the pulley. Pulleys that are not properly aligned can cause
wear and premature belt failures that are not covered under warranty. Please see Serpentine
Drive Section 3.4 for proper alignment procedures.
Copyright RigMaster Power by Mobile Thermo Systems Inc.
09-28-09
Advertisement
