Advertisement
Figure 2-2
Procedure
1. Remove engine cover.
2. Insert breaker bar or ratchet into serpentine belt auto tensioner as shown in figure 2-2
(recommended method).
You may also use an open ended wrench (figure 2-3), but be sure to protect the radiator in
the event that the wrench slips.
3. Lift the breaker bar to release tension on serpentine belt.
4. Remove belt from flywheel pulley while holding tensioner.
5. Release tensioner and remove belt.
6. Replace and route drive belt as shown in figure 2-1.
7. Rotate the engine to ensure that the belt is properly seated on all pulleys before starting the
engine.
Serpentine Belt
Copyright RigMaster Power by Mobile Thermo Systems Inc.
RigMaster Service and Repair Manual
Document # S240909
CAUTION
Figure 2-4
Figure 2-3
Figure 2-5
09-28-09
Advertisement
