Advertisement
S2.10 Replacing the Fuel Filter
If proper procedures are followed during filter service, a minimal amount of air bleeding is
required after changing the filter.
Figure 2-10
Copyright RigMaster Power by Mobile Thermo Systems Inc.
RigMaster Power Service and Repair Manual
Document #S2100909
Inspect the fuel filter every 1000 Hours.
Figure 2-9
Filter Replacement Procedure
1. The fuel shut off valve must be moved to the closed position. (counter
clockwise to 3 o'clock position)
2. Remove the retaining ring on the filter sediment bowl and carefully
remove the bowl and filter cartridge.
3. Drain and clean the filter sediment bowl.
4. Install a new filter with the opening of the filter going over the filter
housing inlet tube.
5. Reinstall the sediment bowl, and retaining ring.
6. Open the fuel shut-off valve and loosen the right bleed screw on the
filter head assembly.
7. Bleed the low pressure system. (see section S5A-2)
8.
Start the engine and check for leaks
NOTE
Bleed Screw
Fuel Shut Off Valve
Fuel Bowl Retaining Ring
Fuel Sediment Bowl
Fuel Filter
Priming Pump
Priming Lever
09-28-09
Advertisement
