6. The blower still works
after the stove is cool
and fuel feed stops.
7.no enough heat wind
8. Ash and smoke fly out. Leak
The problems caused by the owner's improper operation are not our guarantee. We
can supply payment service.
This appliance requires regular maintenance by a competent engineer.
Use only replacement parts recommended by the manufacturer.
NO unauthorized modification of this appliance should be carried out. This would
invalidate the warranty
Electricity control
High temperature switch
(93˚C) is wrong.
The
low
temperature
switch (50˚C) is broken.
Unqualified fuel
Blower
speed
is
high.
Heat exchange tubes are
dirty.
between
connection of convection
motor and venting pipe.
The clean method is
wrong.
Warranty
Page 18 / 19
Cool the stove at least 1 hour then
operate again or change the high
temperature switch (93˚C).
Change this switch.
Use the standard specially pellet.
too
Turn down the blower.
Clean the heat exchange tubes.
the
Use silicon rubber to seal.
Clean the dust in the stove with brush
to ash drawer.