Beep Codes - Dell studio P02E series Setup Manual

Solving Problems

Beep Codes

Your computer might emit a series of beeps
during start-up if there are errors or problems.
This series of beeps, called a beep code,
identifies a problem. If this occurs, write
down the beep code and contact Dell (see
"Contacting Dell" on page 77).
NOTE: To replace parts, see the Service
Manual at support.dell.com/manuals.
Downloaded from LpManual.com Manuals
48
Beep Code Possible Problem
One Possible system board failure —
BIOS ROM checksum failure
Two No RAM detected
NOTE: If you installed or
replaced the memory module,
ensure that the memory module
is seated properly.
Three Possible system board failure —
Chipset error
Four RAM read/write failure
Five Real Time Clock failure
Six Video card or chip failure
Seven Processor failure
Eight Display failure