Buffalo Tech AirStation WMR-300 User Manual page 7

Router functionality is disabled.
3
Power LED (Green or Red)
On (Green):
Power is on and wireless LAN is enabled.
Blinking (Green):
Internal system is booting.
Double blinks (Green):
AirStation is waiting for an AOSS or WPS security key.
Slow blinks (Green):
Power is on but wireless LAN is disabled.
Continuously blinking (Red):
AOSS/WPS error; failed to exchange security keys.
Blinking (Red):
You can see the status as below:
Blinking
Double*
Triple*
4 times*
5 times
Continuously**
Notes:
* Reconnect USB cable. If it blinks again, please contact your vender.
** Do not disconnect USB cable while continuously blinking (red).
4
AOSS Button
To initiate AOSS, hold down this button until the wireless LED flashes (about 1 second). Then, push or click the
AOSS button on your wireless client device to complete the connection. Both devices must be powered on for this
to work.
5
Reset Button
To reset all settings, hold down this button until the Buffalo LED turns red (about 3 seconds). The power must be
on for this to work.
6
Internet Port
10 Mbps and 100 Mbps connections are supported.
7
Factory Default Label
Displays AirStation's SSID, encryption key, PIN and MAC address.
Status
Flash ROM error
Wired LAN error
Wireless LAN error
IP address setting error
Updating firmware
Backing up or initializing settings
Meaning
Cannot read or write on the flash memory.
Wired LAN controller has crashed.
Wireless LAN controller has crashed.
Cannot communicate because WAN-side and LAN-side
IP addresses are same. Change LAN-side IP address of
the AirStation.
Updating firmware.
Backing up or initializing settings.
7