Page 1
Outdoor Cooking Centres Operating and assembly instructions warranty details Model OCCTWB / OCCTWBNG FOR YOUR SAFETY. 1. If you smell gas: Shut off gas to the appliance, if possible. Extinguish any open flame. Open lid. If odour continues, Teppanyaki plate and wok burner immediately call your gas supplier or fire department.
Page 2
More than one million Australians enjoy using Kleenmaid appliances daily. Selected because of their unique design, outstanding performance, excellent quality and unquestionable reliability, each one is value-for-money, 100 per-cent guaranteed and at the top of its class.
G E N E R A L I N F O R M A T TABLE OF CONTENTS CLEARANCES The following minimum clearances from combustible materials must be General Information maintained when the appliance is in use: Safety top – 1000 mm, rear – 450 mm, sides – 250 mm. Outdoor Areas Openings at the rear and sides of the appliance provide air for Pre-Assembly...
CHECKING FOR GAS LEAKS READ CAREFULLY BEFORE ASSEMBLING AND OPERATING NEVER TEST FOR LEAKS WITH A FLAME. YOUR OUTDOOR RANGE BARBECUE. Prior to first use, and at the beginning of each new season (or, if using bottled gas, whenever gas cylinder is changed), you must check for gas FOR YOUR SAFETY: leaks.
Page 5
ALWAYS CHECK FOR GAS LEAKS EACH TIME YOU USE YOUR OUTDOOR RANGE BARBECUE. You should follow this procedure after any of the following: • Not having used the appliance for an extended period of time, • Initial assembly of the appliance, •...
THIS APPLIANCE SHALL ONLY BE USED IN AN ABOVE GROUND OPEN AIR SITUATION WITH NATURAL VENTILATION, WITHOUT STAGNANT AREAS, WHERE GAS LEAKAGE AND PRODUCTS OF COMBUSTION ARE RAPIDLY DISPERSED BY WIND AND NATURAL CONVECTION. ANY ENCLOSURE IN WHICH THE APPLIANCE IS USED SHALL COMPLY WITH ONE OF THE FOLLOWING: •...
GENERAL CARTON CONTENTS While it is possible for one person to assemble the barbecue, Description we recommend asking for the assistance of another person when manoeuvring some of the larger or heavier pieces. Trolley side panel – right Trolley side panel – left Trolley rear panel ASSEMBLY TIPS Castor seat...
Attach castor seats to side panels. NOTE: Castor seats are labelled for correct location L E F T S I D E Phillips flat-head screw " x " Qty: 4 Phillips flat-head screw " x " Qty: 4 Repeat for right side. Door magnets to front Attach side panels to bottom shelf.
Attach the trolley bracket front and rear panel. Trolley bracket front. NOTE: Door magnets to bottom Rear panel Phillips-head screw " x " Qty: 12 Door hinge bracket, top left Flange nut " Door hinge bracket, top left Qty: 12 Attach gas cylinder tray.
Page 10
Attach top right and left door hinges / doors. Insert the bottom door hinge pin into the lower door hinge bracket holes. Depress the spring loaded top door hinge pin and line up with the top hinge bracket holes, and release the pin. Attach door handles and towel rack to the inside panel of the left door.
INSTALL IGNITER BATTERIES • CHECK PERFORMANCE OF BURNERS PRIOR TO INSTALLING • Unscrew igniter cap from control panel. HOT PLATE COMPONENTRY. Refer to page 14 for lighting instructions. • Place supplied AA battery into the igniter slot with positive • DO NOT SMOKE WHEN ATTEMPTING pole facing you.
A S S E M B L Y – G E N E R A L NATURAL GAS INSTALLATION CONNECTING TO, AND DISCONNECTING FROM GAS SOURCE This appliance is also certified for use on natural gas. Contact the manufacturer for advice in relation to using this appliance on TEST FOR LEAKS WITH A natural gas.
Page 13
A S S E M B L Y – G E N E R A L NOW YOUR OUTDOOR RANGE APPLIANCE INSTALL GREASE TRAY AND GREASE TUBE IS READY TO USE • Slide grease tray into position as shown in diagram. Before first use and at the beginning of each season: Please read Safety, Lighting and Operating instructions carefully.
LIGHTING PROCEDURES COOKING TEMPERATURES ‘HI’ setting – Use this setting only for warm up, for searing • THE LID MUST BE IN THE OPEN POSITION FOR LIGHTING. steaks and chops, and for burning food residue from the grill • DO NOT SMOKE AT ALL TIMES plates after the cooking is over.
IF THIS APPLIANCE FAILS TO LIGHT • SHOULD A FLASHBACK FIRE OCCUR IN OR AROUND BURNER TUBES, FOLLOW THE INSTRUCTIONS BELOW. Turn gas off at source and turn burner control knobs to FAILURE TO COMPLY WITH THESE ‘OFF’. Wait at least five (5) minutes for gas to clear, then INSTRUCTIONS COULD RESULT IN retry.
DO NOT USE OVEN CLEANER TO CLEAN CLEANING THE GREASE TRAY RECEPTACLE THE OUTDOOR RANGE. SOME PROPRIETORY BARBECUE To reduce the chance of fire, the grease receptacle should be CLEANERS MAY AFFECT / DAMAGE visually inspected before each appliance use. Remove any SOME OF THE SURFACE COATINGS grease and wash grease receptacle with a mild soap and warm...
Page 17
• BEWARE OF SPIDERS. STORAGE BURNER TUBES SHOULD BE INSPECTED AND CLEANED We recommend that you minimise the exposure of the Outdoor PERIODICALLY. Range to the elements. • SPIDERS AND SMALL INSECTS CAN High moisture content in the air (rain, mist, salt spray etc.) OCCASIONALLY SPIN WEBS OR MAKE can affect metal components and lead to material breakdown.
METHOD 3: Use an air hose to force air through each burner tube. CLEANING BURNER TUBES The forced air should pass debris or obstructions through burner AND BURNER PORTS and out the ports. To reduce risk of FLASHBACK FIRE you must clean the burner Regardless of which burner cleaning procedure you use, we tubes as follows at least once a month in summer and autumn or recommend you also complete the following steps to help prolong...
Page 20
This diagram is provided to assist you identify parts if replacement is necessary. Contact the place of purchase or manufacture to enquire about parts, availability and / or service. Items included in Outdoor Range barbecue specification may differ from parts list, depending on region or specific dealer specification.
Page 21
Description Part # Description Part # P0014605AY Side burner electrode P02606016A Lid bracket P03304030C Electric wire set – 2 contact P02615104A Hot plate P05702020E Gas collector box – with wire P02610036A Hot plate handle P00203021H Thermocouple for hot plate burner P05305013A Hot plate burner P02008027B...
Kleenmaid are not liable for any consequential damage incurred during de-installation and/or re-installation. 2. The appliance is delivered to the Kleenmaid service department or authorised service agent and freight charges both ways are paid by the owner. No liability is accepted for loss or damage during transit.
Page 24
Drawings are not to scale. All information supplied is for general reference purposes only and is on the understanding that Kleenmaid Pty Limited will not be liable for any loss, liability or damage whatsoever arising as a result of reliance of such information.
Need help?
Do you have a question about the OCCTWB and is the answer not in the manual?
Questions and answers