Table of Contents
Advertisement
Troubleshooting
Phenomena that may be easy to be mistaken for machine defects
About the phenomenon confused with a machine defect, check and cope with it
according to the following table.
Phenomenon
The electrical power cord is not plugged in.
Correctly connect the power cord.
The main power source has been interrupted during
operation such as by a power outage (blackout), etc.
Please disconnect the power plug from the power outlet,
and allow the projector to cool down at least 10 minutes,
Power does not
then turn the power on again.
come on.
Either there is no lamp and/or lamp cover, or either
of these has not been properly fixed.
Please turn the power off and disconnect the power plug from
the power outlet, and allow the projector to cool down at least
45 minutes. After the projector has sufficiently cooled down,
please make confirmation of the attachment state of the lamp
and lamp cover, and then turn the power on again.
The signal cables are not correctly connected.
Correctly connect the connection cables.
Signal source does not correctly work.
Correctly set up the signal source device by referring to the
manual of the source device.
Neither sounds
The input changeover settings are mismatched.
nor pictures are
Select the input signal, and correct the settings.
outputted.
The BLANK function for pictures and the MUTE
function for sounds are working.
AV Mute may be active. Refer to the item "Sound does not
come out" and "No pictures are displayed" on the next page
to turn off the MUTE and BLANK functions.
(Continued on next page)
6
Cases not involving a machine defect
http://www.pureglare.com.au
Reference
page
11, 14
54, 55
9
–
15, 16
15, 20
Advertisement
Table of Contents
