Connecting Power Supply; Using The Security Bar And Slot - Projector CP-X201 User Manual

Connecting power supply

At first, make sure that the power switch of the
projector is set to OFF position (marked "O").
1.
Put the connector of the power cord into the
AC inlet of the projector.
2.
Firmly plug the power cord's plug into the
outlet.
WARNING
►Please use extra caution when connecting the power cord, as
incorrect or faulty connections may result in fire and/or electrical shock.
• Only use the power cord that came with the projector. If it is damaged, contact
your dealer to newly get correct one.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
• Never modify the power cord.

Using the security bar and slot

A commercial anti-theft chain or wire up to
10 mm in diameter can be attached to the
security bar on the projector.
Also this product has the security slot for the
Kensington lock.
For details, see the manual of the security
tool.
WARNING
►Do not use the security bar and slot to prevent the projector
from falling down, since it is not designed for it.
CAUTION
►Do not place anti-theft chain or wire near the exhaust vents. It
may become too hot.
NOTE
• The security bar and slot is not comprehensive theft prevention
measures. It is intended to be used as supplemental theft prevention measure.
Anti-theft chain or wire
http://www.pureglare.com.au
AC inlet
Security slot
Security bar
Setting up
Power cord