Rodgers 690 Owner's Manual page 61

Restoring the Factory Settings
The 690 and 610 factory settings can be restored in three stages usmg
the SET and GENERAL CANCEL pistons as follows:
1 . Hold SET and press GENERAL CANCEL. The SET light will go off and
the MIDI coupler data blocks will be set to factory default.
2. Continue to hold SET and GENERAL CANCEL for about 5 seconds until
the SET light comes back on. The General and Divisional pistons for
the selected memory will be restored to factory default. Repeat this
procedure for each memory bank you wish to restore.
3. Continue to hold SET and GENERAL CANCEL for about 5 seconds more
until memory 1 piston lights. The Melody and Bass Couplers will be
restored to their factory default split points and the Chorus will be
set to its factory tuning. The Tutti on the 690 will also be set to the
factory default setting.
Receiving A Program Change
In addition to the program changes shown on page 16, Divisional pistons
will respond to Program Changes as follows:
Channel
12
Program Change 21-26 will select Great Divisional pistons 1-6.
Channel
13
Program Changes 21-26 will select Swell Divisional pistons 1-6.
Channel
14
Program changes 21-23 will select Pedal Divisional pistons 1-3.
Octave Transpose
To return a MIDI Coupler to standard pitch repeat the procedure
described on page 12 and return the TRANSPOSER from +1 to 0 if returning
from one octave sharp. Return the TRANSPOSER from -1 to 0 if returning
from one octave flat.
Rodgers P/N 1905-193