Table of Contents
Advertisement
HOW TO CONNECT ST CABLES
1. Remove the plastic
cover from the outside of the ST transmitter
(located
on
transport)
and receiver
(located
on processor).
2. Remove the plastic
cap from both ends of the ST cable.
3. Locate the key tab on the end of the ST cable.
4. Locate the slot on the top of the ST receptacle.
5. Slide the cable connector into the ST receptacle,
with the key guided into the
designated slot.
6. Gently push the connector
into place,
depress the internal
spring,
and twist
the outer collar
clockwise to secure the outer ring to the posts on the chassis
connector.
7. Use the same procedure for the processor
input.
ST/TIME
SYNC OUTPUT
The ST connector
labeled
ST/Time Sync can be switched
between
Time
Sync and a normal data
output.
The KPS-20t comes with this
output
Set for
Time Sync. Follow the procedure below to switch it to a data output:
1. Turn the
power amplifier
Off and the preamplifier
to Mute or Standby
2. Turn the two thumbscrews
counterclockwise
until
they release
from the
chassis
3. Hold the thumbscrews and pull the panel/board
assembly straight
out of the
unit
4. On the circuit
board there is a switch labeled
Time Sync on one side,
Data
on the other
5. Move the switch to the Data
6. Slide the board back into the chassis
7. Firmly press the board into its
mating connector
8. Turn the thumbscrews clockwise
until
they are tight
17
Hide quick links:
Advertisement
Table of Contents
