1. Introduction Serial ATA (SATA) is the latest form of computer connectivity, featuring faster transfer speeds, easier configuration, and the ability to hot-swap drives. With the Vantec 2-Port eSATA ExpressCard, you can add the features and functionality of eSATA to your notebook.
3. Features / Specifications Features ● Easily Add Two eSATA Ports to your ExpressCard Equipped Notebook ● Transfer Rate up to 3.0 Gbps ● Easy Plug & Play Installation Specifications ● eSATA (External SATA) Connector ● ExpressCard 34mm Form Factor ●...
4. Type in E:\ (If your CD-ROM/DVD is E:\) then click “Browse”. 5. Points specify a location, example E:\UGT-ST450CB\Driver\ WinXP_2000_2003_NT, and click “OPEN” then “OK” 6. When the wizard indicates that it found a driver for the device click 'Next' 7.
3. Insert the Driver CD in your CD-ROM/DVD drive, check Specify a location, uncheck the other boxes, click Next, type in E:\ (If your CD-ROM/DVD is E:\). Click Browse. 4. Points specify a location, example E:\UGT-ST450CB\Driver\WinXP_2000_2003_NT, and click “OPEN” then “OK”...
5.2. Software Installation Mac OS X 1. Insert the Driver CD into your CD-Rom/DVD. 2. Open the Mac folder and click the “Sil3132.pkg” installer. 3. Click “Continue”...
Page 8
5.2. Software Installation Mac OS X 4. Review the provided Read Me. Click “Continue”. 5. Review the License agreement. Click “Continue”.
Page 9
5.2. Software Installation Mac OS X 6. Click “Agree” to accept the terms of the License agreement and proceed with the installation. 7. Select the system hard disk drive.
5.2. Driver Installation Mac OS X 10. Click “Continue Installation” to acknowledge the restart warning. 11. Click “Restart” to reboot the computer and complete the installation. To confirm the driver installation In case of a driver installation failure, an error message will appear after you reboot the computer.
5.3. Verifying The Installation Windows 2000/XP/Vista 1. Right click on 'My Computer' icon, select 'Properties', left click on 'Hardware' tab, and then on 'Device Manager' button. 2. Double click on 'SCSI and RAID Controllers', If there is no yellow '! ' or ' ? ' in front of 'Silicon Image SiI 3132 SATALink Controller', the driver is started correctly.
3. Select 'SCSI Adapters' from the Control Panel. 4. Select the 'Drivers' tab and click 'Add'. 5. . Click 'Have Disk'. 6. . Insert the Driver CD in your CD-ROM/DVD drive and press 'Enter'. 7. Choose ' E:\UGT-ST450CB\Driver\WinXP_2000_2003_NT ' and click 'OK'.
6. Warranty The Vantec 2-Port eSATA ExpressCard comes with a 1 year limited warranty. If your unit should become defective within that time frame, please go to http://www.vantecusa.com for information on how to receive warranty exchange or repair. Cosmetic defects and missing parts are not covered under this warranty.