How To Initialize The Lcd Tv/Dvd - FUNAI LCD TV/DVD Service Manual

HOW TO INITIALIZE THE LCD TV/DVD

The purpose of initialization is to place the set in a new out of box condition. The customer will be prompted to
select a language and program channels after the set has been initialized.
To put the program back at the factory-default, initialize the LCD TV/DVD using the following procedure.
< DVD Section >
1. Turn the power on.
2. To enter the service mode, press the service
button on the service remote control unit.
- To cancel the service mode, press [POWER]
button on the service remote control unit.
3. To put the LCD TV/DVD into the DVD mode, press
[PREV CH] or [CH RETURN] on the remote
control unit.
4. To put the LCD TV/DVD into the Flash clear mode,
press [SOURCE] or [INPUT SELECT] buttons on
the remote control unit in that order within five
seconds.
The following screen appears.
Flash Memory Clear : OK
CHUCKING ON
When "OK" appears on the screen, the factory
default will be set.
5. To exit this mode, press[CHANNEL UP/DOWN]
button to go to TV mode, or press [POWER] button
to turn the power off.
Note: The name of buttons may vary with the brand
of unit.
< LCD TV Section >
1. Turn the power on.
2. To enter the service mode, press the service
button on the service remote control unit.
- To cancel the service mode, press [POWER]
button on the service remote control unit.
3. Press [INFO] button on the service remote control
unit to initialize the LCD television.
4. "INITIALIZED" will appear in the upper right of the
screen. "INITIALIZED" color will change to green
from red when initializing is complete.
7-1 A94F0INT