Operating Your Kav-280P; Preamplifier Operation; Tape Input And Output - Krell Industries KAV-280p Instructions For Use Manual

Operating Your KAV–280p
Preamplifier
Operation
Note
Note
Krell KAV–280p
This section provides information about operating the KAV–280p.
The KAV–280p provides basic input selection and volume control
operation from the front panel. The remote control includes addi-
tional preamplifier functions as well as CD transport and amplifier
controls. See Remote Control, on page 12, for more information.
The KAV–280p Remote Control Premplifier is easy to operate.
1. When the preamplifier is in stand-by mode, with the red stand-
by LED (3) illuminated, turn the preamplifier on by pressing the
power button (1), or pressing the power key (22) on the remote
control. The blue power LED (2) illuminates, and the red stand-
by LED (3) turns off. The preamplifier is now ready for opera-
tion.
2. To access preamplifier functions via the remote control, press
the pre key (23) on the remote control.
When you press a function key on the remote, the blue power LED (2)
will flash.
3. Choose a listening source and select the source input.
4. Start playing the source. Set the volume to a comfortable lis-
tening level using the level knob(10) or volume keys (28).
5. When changing sources, lower the volume to the off position or
mute the output (see Mute, on page 13). This insures that the
next source played will not damage your system with a high
output transient.
6. To turn the preamplifier off, press the power button (1) or
power key (22). The red stand-by LED (3) illuminates.
When powering up any system, always turn amplifiers on last. When
powering down, always turn amplifiers off first.
17