Eq Knobs - Traktor Kontrol S8 Manual

These assignments aren't mutually exclusive, so you can send signal to either one or both FX
Units at the same time.
If you activate both FX assign buttons, your track will first run through FX1, then FX2.
TRAKTOR's FX only work if a channel is set to TRAKTOR mode. If you need to run an exter-
nal device through TRAKTOR's FX, set it to TRAKTOR mode and choose the
flavor.
Assigning FX Units 3 and 4
TRAKTOR supports up to 4 FX Units. Activate the two additional FX Units in TRAKTOR's pref-
erences: Preferences > Effects > FX Unit Routing > 4 FX Units.
To assign a channel to FX Unit 3 or 4:
Press SHIFT + FX
►
Unit 4.
Control FX Units 3 and 4 via S8's Performance knobs and buttons.
►
4.4.1.4

EQ Knobs

Each channel sports a 3-band EQ section: HI,
nal balance between different tracks by increasing or decreasing the corresponding frequency
band's volume.
assign button. The left button assigns to FX Unit 3, the right one to FX
MID and LOW knobs allow you to restore the to-
TRAKTOR KONTROL S8 - Manual - 211
Hardware Reference
The Mixer
Live Input Deck