Installing The Iso Cable; Installing The Usb Cables - Parrot Asteroid Smart User Manual

Hide thumbs Also See for Asteroid Smart:

Table of Contents

Installing the ISO cable

Connect the audio and power connectors of the Parrot ASTEROID Smart to the ones

of your vehicle.

Note: Use the provided cable ties to make sure the cables are well fixed to the car stereo.

Insert one of the cable ties into the slots in the top of the back of the car stereo.

Once the connections are made, check your installation. To do so, turn the ignition on

then off. The "Goodbye" message must be displayed. If it is not the case, it is necessary

to swap the positions of the red and yellow wires. Indeed, the red wire of the power

cable must be connected to the 12V ignition, the yellow wire to the permanent 12V and

the black wire to the ground. This can be done simply by reversing both bullet

connectors located on the Parrot wiring.

Connect the USB cables to the Parrot ASTEROID Smart. We recommend you connect

all audio cables to the Parrot ASTEROID Smart even if you do not plan on using them.

Route the audio cables to a suitable location in your vehicle such as the glove box or

arm rest compartment. It may be necessary to drill a hole in your dashboard to do so.

Avoid using USB extension cables.

The USB cable (1.2m - 2A) to which you will connect the USB / iPod cable extension

must be connected to its specific white USB port. "iPod" is written above it.

To guarantee an optimal reception quality we recommend you do not connect your

internet USB key 3G on the Parrot ASTEROID Smart directly : use the USB cable to

install your device on the dashboard (or any other open area).

Installation

Table of Contents