Rf Control - Nokia NHM-8NX Series Troubleshooting Instructions

PAMS Technical Documentation
1 Same procedure for PCN as for GSM.
2 Remember to tick Save To Product.
3 Stop. Ends tuning and does what you have ticked.

RF control

This menu can be placed in maintenance or in tuning dependent of Phoenix.
It is meant to check the receiver or transmitter without going in call. It works very much
like a call, but you have control via the PC, and not via the tester. The TX mode GSM900
can select between Free, High and low mode. It changes the PA mode, but changes also
the power level if a level is selected that is not supported in that mode.
If you want to tune at other channels than the default, then you must select it first in RF
control and then start the tuning.
Issue 1 05/02
ãNokia Corporation
NHM-8NX
Troubleshooting Instructions
Page 59