Advertisement
Throttle and LED Display
Throttle
Install an eZee Kit Throttle
in place of your original
right-hand grip on standard
7/8" handlebars. Orient the
throttle so that the switch
faces towards the rear of
the bicycle and the thumb-
switch is comfortable to
turn on and off.
Remove the grip from the bicycle and slide the throttle in place. Tighten the setscrew
•
with a 2.5mm Allen wrench.
Removing handgrips can sometimes be tricky. Bike shops usually use compressed air;
•
other tricks involve squirting hairspray or lubricant under the rubber. The eZee Kit
Throttle is complete with a grip, so it is always an option to cut off stubborn units with a
sharp knife.
LED Indicator
The Green/Yellow/Red Indicator shows the battery voltage level. Install an eZee Kit battery
indicator on the left hand side of your handlebars, opposite to the throttle. Orient the indicator
so that the LED faces towards the rear of the bicycle. The short 5-pin connector connects
directly to the throttle. Note the on/off switch of the LED indicator is not currently wired and so
the switch does not have any effect.
Wiring
The next step is wiring the components together, running the
wires together along the frame and neatly securing the wires
to the bicycle tubing.
Run the motor controller wire from the battery bag to
•
the hub motor following the bicycle frame.
Connect the LED indicator wire back from the
•
handlebars, back to the controller in the battery bag.
Secure the Wires:
To make your setup look pro, route the wires along the bicycle tube in a tidy fashion, using cable
ties.
The motor wires can be run from the motor up along the front fork to meet at the
•
crossbar with the battery indicator wire. Together, they can follow the crossbar back to
the controller in the battery bag.
Renaissance Bicycles
eZee Kit Installation Guide Version 1.2
Throttle Connector
5
Advertisement
