Using A Parallel Fence; Using A Parallel Fence With Guide Rods; Vacuum Attachment; Fitting The Parallel Fence - DeWalt D26204-XE Instruction Manual

Using a Parallel Fence (Fig. 8A)
A basic parallel fence is included with the D26204-XE and works with the fixed base.
The basic parallel fence D262003-XJ is available as an accessory for the other
models and may be purchased from your local retailer or service center at extra cost.
1. Remove the motor unit from the base unit. Refer to Motor Quick Release.
2. Remove flat head screws (MM) from storage holes on parallel fence.
3. Slide parallel fence (Y) into parallel fence slot (Z) on side of base. Insert the two
flat head screws through the appropriate holes in the sub base to secure the
parallel fence. Tighten hardware.
4. Follow all instructions included with the parallel fence.
NOTE: To remove the parallel fence, reverse the above procedure. After removing
parallel fence always replace the two flat head screws (MM) into the storage holes on
the parallel fence to prevent loss.
FIG. 8A
Z
Using a Parallel Fence With Guide Rods, plunge base only)
A parallel fence with guide rods may be included with your plunge base unit.
FITTING THE PARALLEL FENCE (FIG. 1, 8B)
1. Slide the guide rods (OO) into both holes (M) in the router base.
2. Attach the thumb screws (NN) and springs(QQ) to the base.
3. Tighten the thumb screws (NN).
4. Slide the parallel fence (GG) over
5. Attach thumb screws (NN) and
6. Tighten the thumb screws (FF)
ADJUSTING THE PARALLEL FENCE
(FIG. 1, 8C)
Follow the assembly instructions
included with the parallel fence.
1. Draw a cutting line on the material.
2. Lower the router carriage until the cutter
3. Lock the plunge mechanism by releasing
4. Position the router on the cutting line.
MM
5. Slide the parallel fence (GG) against the
Vacuum Attachment (Fixed Base Only, Fig. 9)
Y
WARNING: To reduce the risk of injury, turn unit off and disconnect it from
power source before installing and removing accessories, before adjusting or
when making repairs. An accidental start-up can cause injury.
To connect the router to a vacuum cleaner for dust collection, follow these steps:
1. Remove the motor unit from the base unit. Refer to Motor Quick Release.
2. Attach vacuum attachment accessory (V) to the base as shown. Tighten thumb
3. Attach hose adapter to vacuum attachment accessory.
10
FIG. 8B
the rods.
NN
springs(QQ) to the parallel fence.
QQ
temporarily. Refer to Adjusting the
Parallel Fence.
is in contact with the workpiece.
the plunge lock lever (P)
The outer cutting edge of the cutter must
coincide with the cutting line.
workpiece and tighten the thumb screws (FF).
screws (W) securely by hand.
FF
M
OO
GG
QQ
FIG. 8C
FF
GG
QQ