Getting Started; Making A Network Plan - Vingtor Stentofon AlphaCom XE Series Installation, Configuration & Operation

2

Getting Started

AlphaCom XE7
AlphaCom XE7
Oslo head office
SIP ISDN
Gateway
Public
telephone
network
LAN Oslo
Network IP 10.0.1.0
Mask 255.255.255.0
Router Oslo 10.0.1.1
AlphaCom Oslo 1 10.0.1.10
AlphaCom Oslo 2 10.0.1.11
iPBX 10.0.1.20
SIP ISDN Gateway 10.0.1.21
8
This section is a step-by-step guide to getting the AlphaCom XE system
up and running.
1. Sketch a network overview
2. Unpack and install hardware
3. Perform cold start
4. Connect to AlphaWeb
5. Configure IP Settings
6. Change default user name and password
7. Enter the license key
8. Modify default settings (optional)
9. Perform a system backup
The AlphaCom XE servers are shipped with a default factory setting and
the system will work straight out of the box. If no changes to the default
factory settings are required, it is enough to perform steps 1 to 6 to set
up a working system.
Some changes to the default factory settings are often required, for
instance if the default numbering plan and naming in the directory shall
be updated to reflect the floors in a building, then the optional steps
should also be performed.

2.1 Making a Network Plan

Make a plan of the network topology as shown in the example below.
Internet Service Provider
iPBX
Network IP
Mask
Router Horten
AlphaCom Horten 1
AlphaCom XE - Installation, Configuration & Operation
WAN
Internet
VPN (IPsec)
LAN Horten
10.0.5.0
255.255.255.0
10.0.5.1
10.0.5.10
AlphaCom XE7
Horten branch office
AlphaCom XE7
USA branch office
LAN USA
Network IP 10.0.10.0
Mask 255.255.255.0
Router USA 10.0.10.1
AlphaCom USA 1 10.0.10.10
A100K10805