Writing Main Microprocessor (Q201) Procedure; Necessary Equipment; Writing Procedure - Marantz PM7001 series Service Manual

4. WRITING MAIN MICROPROCESSOR (Q201)
PROCEDURE
Microprocessor needs writing software, when a
microprocessor (Q201) is replaced.

NECESSARY EQUIPMENT

• Windows PC (OS : Windows2000 or WindowsXP) with
Serial Port
• RS-232C Cable straight type
(9 Pin female - 9 Pin female)
• Connection JIG (90M-PM11S1JIG)
• Writing Tool and some files
(FlashProg.exe, etc... in TM86FH47pass folder)
• Writing data (PM7001_xxxx.h16)
NOTE: xx is a revision number.

WRITING PROCEDURE

Disconnect the mains cord from the unit.
Connect RS-232C on the connection JIG and Serial Port of
windows PC with RS-232C cable.
Connect FPC (upside contact) to the rear panel of the unit
from connection JIG.
Reconnect the mains cord to the unit.
Put the "TM86FH47pass" folder into anywhere on your PC's
hard disc.
• Windows PC (OS : Windows2000
• RS-232C
•
•
•
Windows PC
INSERT POINT
Connection JIG (90M-PM11S1JIG)
TM86FH47pass
5
Q201
Serial
(90M-PM11S1JIG)
(M86FH47pass
(PM7001_xxxx.h16)
Serial Port
Windows PC
Q201
WindowsXP)
(9Pin -9Pin )
FlashProg.exe )
RS-232C
FPC
RS-232C Cable