Advertisement
Technical specifications Pro-Ject Amp Box DS
Power output:
Frequency response:
Channel separation:
Noise floor:
THD:
Gain:
Pre in:
Input sensitivity:
Input impedance:
Speaker connectors:
Trigger:
Trigger in and out:
Outboard power supply:
Power consumption:
Dimensions W x H x D (D with sockets): 103 x 72 x 144 (163)mm
Weight:
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
©
Copyright
2012. All rights reserved.
2 x 100W/180W at 8 ohms/4 ohms (both channels driven)
2 ohms drive capability
10Hz - 50kHz (+0dB, -3)
> 40dB at 20kHz
> -90dB (A weighted)
< 0,1% at 90W
26dB
1 pair RCA/phono sockets
1,5V
100kohms
4mm banana plugs, spades connectors or naked wire
12V DC switching voltage
2-pole co-axial 2,5mm co-axial jack
±48V/2,5A DC, suitable for your country's mains supply
2,5A DC, <1W in standby
1.400g without power supply
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
© Audio Trade GmbH · Pro-Ject Amp Box DS · Revision 2012.9.1
3
Advertisement
