Hanging Pre-Assembled Unit - Brant Radiant Heaters QTD Series User Instruction

3.0 Installation •

Hanging Pre-Assembled Unit

Hanging Pre-Assembled Unit
1
Raise the assembled unit from assembly station to prepared hanging location. NOTE: This can be
done manually or with a winch system.
2
Attach two chains to exchanger connection hanging bracket (TP-6079). Secure S-hooks.
3
Attach the third chain located furthest from the gas and electrical connections to the reflector end
assembly (TP-6089A) and secure S-hook.
4
Raise or lower the unit to desired mounting height.
Figure 3.6 • Hanging the Heater
16
QTD Series