Cutting System; Caring And Cleaning; Service Recommendations - Electrolux 32cm Lawn Mower Important Information Manual

1. Start mowing from the outside edge of the lawn,
mowing in strips in alternate directions (U).
2. Mow twice a week in the growing season, your
lawn will suffer if more that one third of its length
is cut at one time and this may also result in poor
collection.
Please Note:-
Do not overload your Lawnmower
When mowing in long thick grass a first cut with the
cutting height adjusted to its highest setting, see
Cutting Height Adjustment, will help reduce motor
overload and will help prevent damage to your
lawnmower.
V1 - blade bolt; V2 - blade; V3 - blade adaptor
• WARNING!
Before cleaning, servicing or repairing the
lawnmower ALWAYS remove the safety key to
prevent unintentional starting.
• Always handle the blade with care - sharp
edges could cause injury. USE GLOVES.
Removing the Blade
1. To remove the blade bolt, hold the blade firmly
and with the spanner provided loosen the blade
bolt by turning it anti-clockwise (V).
2. Remove the blade bolt and blade.(V)
3. Inspect for damage and clean as necessary.
Fitting the Blade
1. Ensure the blade adaptor is located correctly.(V)
• IMPORTANT
It is very important that you keep your
lawnmower clean. Grass clippings left in any of
the air intakes or under the deck could become
a potential fire hazard.
• IMPORTANT
Never use water for cleaning your lawnmower.
Do not clean with chemicals, including petrol,
or solvents - some can destroy critical plastic
parts.
Cleaning (W, X, Y & Z)
• USE GLOVES
1. Remove grass from under the deck with brush.
2. Using a soft brush - remove grass clippings
from all air intakes, the discharge chute and the
grass box.
3. Wipe over the surface of your lawnmower with
a dry cloth.
At the End of the Mowing Season
1. Replace blade, bolts, nuts or screws, if
necessary.
2. Clean your lawnmower thoroughly.
• Your product is uniquely identified by a silver and black product rating label.
• We strongly recommend that your product is serviced at least every twelve months, more often in
a professional application.
How to Mow
Your battery should be kept on charge
continuously when not in use. The battery
should be fully charged before use.
The area you can cut from one charge depends on
the conditions in which you are mowing.
To increase the area you should:
• Cut the grass more frequently.
• Raise the height of cut.
Cutting in tough conditions:
An overload Cut out is built into your machine. The
machine will cut out if you are trying to cut too much
grass.

Cutting System

2. Fit the blade to the blade adaptor with the sharp
3. Re-assemble blade bolt through blade and blade
4. Hold the blade firmly and tighten blade bolt firmly
5. Do not use a longer spanner.
• Renew your metal blade after 50 hours
• If the blade is cracked or damaged replace it
• Never use a blade bolt if the insulated head is

Caring and Cleaning

Storing your Lawnmower
1.
2.
3.
4.
5.
Changing the battery
1.
2.
3.

Service Recommendations

Note: To reduce the cutting load the rear wheels
may be raised higher than the front wheels.
edges of the blade pointing away from the blade
adaptor.
adaptor.
with the spanner provided. Do not over tighten.
mowing or 2 years whichever is the sooner -
regardless of condition.
with a new one.
damaged cracked or missing.
Remove safety key before storing
Do not store your lawnmower immediately after
use.
Wait until the motor has cooled to avoid a
potential fire hazard.
Put battery on charge.
Store in a cool, dry place where your
lawnmower is protected from damage.
Contact your local approved service centre
when the batteries need to be replaced.
Do not adjust any of the wiring or connections.
The batteries are sealed lead batteries that
contain corrosive acid. If the acid should come
into contact with the eyes, rinse thoroughly with
plenty of water and seek medical attention. If
the acid comes into contact with the skin, rinse
thoroughly with plenty of water and protect the
eyes from possible splashing.
ENGLISH - 4