Electrical Adjustment - Sanyo VPC-HD1000 Service Manual

3. ELECTRICAL ADJUSTMENT

3-1. Table for Servicing Tools
Ref. No. Name
J-1 Pattern box
J-2 Calibration software
J-3 Chroma meter
J-4
Spare lump
J-5 Discharge jig
J-6
Collimator
Spare lump (collimator)
J-7
J-8
Siemens star chart
Download the calibration software and the firmware
from the following URL.
http://www.digital-sanyo.com/overseas/service/
Place the DscCalDi.exe file, camapi32.dll file and
QrCodeInfo.dll file together into a folder of your
choice.
J-1
J-4
J-8
3-2. Equipment
1. AC adaptor
2. PC (IBM R -compatible PC, Pentium processor, Window
98 or Me or 2000 or XP)
Part code
Number
VJ8-0190
1
1
1 VJ8-0192
1 VJ8-0191
1 VJ8-0188
1 VJ8-0260
1 VJ8-0282
1
J-3
J-5
3-3. Adjustment Items and Order
1. Lens Adjustment (Infinity)
2. Lens Adjustment (1m)
3. AWB Adjustment
4. CCD White Point Defect Detect Adjustment
5. CCD Black Point And White Point Defect Detect Adjust-
ment In Lighted
Note: If the lens, CCD and board and changing the part, it is
necessary to adjust again. Item 1-5 adjustments should be
carried out in sequence.
3-4. Setup
1. System requirements
Windows 98 or Me or 2000 or XP
IBM R -compatible PC with pentium processor
USB port
40 MB RAM
Hard disk drive with at least 15 MB available
VGA or SVGA monitor with at least 256-color display
2. Installing USB driver
Install the USB driver with camera or connection kit for PC.
3. Pattern box
Turn on the switch and wait for 30 minutes for aging to take
place before using Color Pure. It is used after adjusting the
chroma meter (VJ8-0192) adjust color temperature to 3100 ±
20 K and luminosity to 900 ± 20 cd/m
the lump and its circumference are high temperature during
use and after power off for a while.
4. Computer screen during adjustment
Calibration
Upload
AWB
Firmware
Focus
QrCode
UV Matrix
Cal Mode
PAF Cal.
OK
EVF
Cal Data
LCD Type
OK
USB storage
Get VID
Set PID
Backrush pulse :
Get
3-5. Connecting the camera to the computer
1. Use the supplied AC adaptor and power cord to connect
the docking station to a power outplet, and set the camera
in the docking station. (Open the monitor.)
2. Use the supplied dedicated USB interface cable to connect
the camera to the computer.
3. Choose the "COMPUTER", and press the SET button.
Next, choose the "CARD READER", and press the SET
button.
– 17 –
2 . Be careful of handling
LCD
R Bright
B Bright
RGB Offset Gain
Tint Phase
VCO
H AFC Test
Set Serial
Set
Set Rev. Set
Set
VCOMDC
VCOMPP
Hall Cal.
Setting
Language
Video Mode
Factory Code