Before You Start Trenching - terrasaw TS-400 Operator Owner's Manual

1. Give the machine a good visual inspection before starting/Re-starting.
2. Carry out all safety instructions as listed on page 2.
3. Check with local authorities for any underground services. Most utility
providers (for example Telecom, local electricity and gas suppliers) provide
a free cable location and advisory service, to prevent accidental disruption
of services. In rural areas, check also with local farmers or landowners who
may have detailed knowledge of utilities. Note: in many locations (e.g. along
roadsides and near subdivisions) excavation may have occurred after utilities
were laid. This can result in cables etc. being encountered unexpectedly at
shallower depths than regulations would suggest.
4. Check along your desired trench route clearing any obstructions, branches,
stones etc. and any other object which may either obstruct the trencher or
cause you to slip/lose your footing. If a long continuous trench is planned,
consider fitting the optional Terrasaw wheel support accessory.
IMPORTANT: Use of the Terrasaw in Dusty Conditions
5.
In some fine dusty soils there is a risk that harmful dust may be drawn into
and through the powerhead air filter resulting in damage to the engine. If
dusty conditions are encountered special precautions must be taken (eg.
the digging area should be dampened prior to trenching and/or a fine water
spray used during operation, with filters cleaned frequently. Where practical,
work with wind from behind the operator.
See also maintenance, cleaning & storage section on page 11.
Terrasaw Industries Ltd will not be liable for damage to any powerhead
resulting from dust intake - refer warranty section.
Please feel free to contact us at any time if you would like further advice or
guidance on this or any other aspect of using your Terrasaw.

Before You Start Trenching

7