terrasaw TS-400 Operator Owner's Manual page 6

9. Refit the Terrasaw drive chain
10. Refer to your chainsaw operators
guard. With securing bolt drawn
manual and follow the instructions
back slide the chain guard into the
to reduce chain bar oil feed to its
retaining channel on main block
minimum recommended setting. If
and push firmly home with the heel
the oil feed setting is not reduced
of your hand (Fig. 5). Re-tighten excessive oil spray will result and
may affect clutch performance.
the guard securing bolt.
Note: Very little oil is required
because the drive chain is not being
10. Roll power head onto its right side
contaminated by wood chips, gum,
(on a surface that will not scratch
dirt etc. but never run drive chain
chain cover
without oil. Lubrication should be
so that you have a clear view of
checked after the first few minutes
digging bar securing bolts. Using
of operation. Remember: If refitting
the spanner provided undo and
the chainsaw timber bar, ensure the
set aside the two large securing
oil feed is reset to manufacturer's
bolts and large flat washer that
recommended setting.
(will) attach the digging bar to the
main block of the Terrasaw (Fig.
6).
11. Roll power head onto its right side
(on a surface that will not scratch
chain cover instructions, etc) so
11. Hold the digging bar as shown
that you have a clear view of
(Fig. 7), with the bar slot facing
digging bar securing bolts. Using
towards the main block body.
your standard powerhead spanner
Note: Digging bar is reversible,
undo and set aside the two large
but the digging chain direction is
securing bolts and large flat washer
critical (Fig. 8).
that (will) attach the digging bar to
the main block of the Terrasaw. (Fig
12. Loop the digging chain around
6)
the nose sprocket of the digging
bar (Fig. 7). Note: The digging
chain must be assembled with
12. Hold the digging bar as shown (Fig
the directional notches on rear/
7), with recessed side of bar slot
trailing edge of teeth as the chain facing towards the main block body
and Terrasaw bar logos upright.
runs along the top of the digging
bar (Fig. 8). Important: Fitting
digging chain in reverse will cause
13. Loop the digging chain around the
a dramatic loss of performance.
nose sprocket of the digging bar
(Fig 7). Note: The digging chain
13. Holding the bar and chain in one
must be assembled with the
hand, loop the digging chain over
directional notches on rear/trailing
drive sprocket with the other hand.
edge of teeth as the chain runs
Engage the slotted section of bar
along the top of the digging bar (Fig
to the matching raised section of
8). Important: Fitting digging chain
the main block and slide the bar to
lightly tension the chain (Fig. 9).
instructions, etc)
Fig. 6
Fig. 7
Fig. 9
Fig. 8
5