terrasaw TS-400 Operator Owner's Manual page 7

14. Reinstall the large washer and two
in reverse will cause a dramatic loss
large securing bolts and lightly
of performance.
tighten.
15. Using a screwdriver, inserted in the
14. Holding the bar and chain in one
tensioner slot (Fig. 10). Leaver the hand, loop the digging chain over
drive sprocket with the other hand.
digging bar away from the Square
Engage the recessed slotted
main block. While keeping tension
section of bar to the matching
on the digging bar, securely tighten
raised section of the main block and
the bolts (Fig. 11).
slide the bar to lightly tension the
chain (Fig 9).
Note: The chain tension should allow
correctly installed chain to sag
approximately half the height of
15. Reinstall the large washer and two
the chain as measured in the
large securing bolts and lightly
middle of the bar (Fig. 11).
tighten.
16. Fit the plastic dirt guard extender
as shown in Fig. 12. Note that this
16. Using a screwdriver, lever the
fits on the outside of the metal dirt digging bar away from the drive
sprocket (Fig 10) and while keeping
guard.
tension on the digging bar, securely
tighten the bolts (Fig 11).
17. Your Terrasaw is now ready for
operation! Please refer to both
Note: The chain tension should allow correctly installed chain to sag approximately
your Terrasaw and Powerhead
half the height of the chain as measured in the middle of the bar (Fig 11).
user manual for correct and safe
operation.
17. Fit the plastic dirt guard extender as shown in Fig 12. Note that this fits on the
inside of the metal dirt guard. If you
anticipate dusty digging see next
section.
18. Your Terrasaw is now ready for
operation!
your Terrasaw and chainsaw user
manual for correct and safe
operation.
6
Please refer to both
Fig. 10
Fig. 11
TERRASAW DIRT GUARD EXTENDER
TERRASAW DIRT GUARD EXTENDER
METAL GUARD
(shown detached)
METAL GUARD
(shown detached)
Fig. 12
Fig. 12
PLASTIC GUARD
EXTENDER
NYLOC NUTS
(on bolts through
PLASTIC GUARD
rear of metal guard)
EXTENDER
LARGE METAL
NYLOC NUTS
WASHER
(on bolts through
rear of metal guard)
LARGE METAL
WASHER